Dodge Challenger Headlight
Guards
Part #
ACC-DCH-HG108T,
ACC-DCH-HG106C
Included:
4 Headlight lens film guards [2 inside lens guards, 2
outside lens guards], 2 Fog light lens guards, Small felt
Squeegee.
For
installation you will need: Household Rubbing Alcohol, a
soapy water mixture of one full spray bottle of water with a
couple of drops of baby shampoo or mild dish detergent.
WARNING: It
is very important to follow every step without skipping
anything. To ensure that you mount your lens guards
professionally.
1.
Prepare both headlight lens by first washing with soap and
water to remove dirt and grime. Dry completely and scrub the
lens with household Rubbing Alcohol.
2.
Place your unpeeled headlight guard over your headlight and
make note of its fit. You now have an idea of how it sits on
the plastic Headlight lens so remove the guard and spray
your mixture of soapy water directly on the headlight lens
and on your new headlight guard soaking it down as you peel
the release liner.
Once both
the headlight lens and the lens guard are completely
saturated place the guard on the lens and position it into
place.
3.
You have been provided with a soft squeegee. Starting at the
center of the light lens use the squeegee to work the fluid
out in all directions until the lens guard has become
completely adhered. The most difficult step for the
installation comes with reaching the far side of lens
that are not as easily accessible. A household hair dryer
may help if some areas become stubborn for any reason.
4.
Repeat the entire process for the opposite side.
5.
Repeat the entire process for the Fog lights as well.
|
